CureZone   Log On   Join
Sorry! More questions!
 
AgnesT Views: 1,089
Published: 15 years ago
 

Sorry! More questions!


I am still a bit unclear about what is right.

When I first make my CS, there are no visible silver particles. However, the next day the liquid is still clear, but I can see sparklies floating. I've been just straining it again. Is this normal and is straining the proper thing to do?

Today I was making a batch and everything was going great. Some gunk started building up on the rod so I unplugged it, took it out and wiped it on a clean paper towel. When I stuck it back in, white vapor started coming off. It is my understanding that the milky stuff is bad, right, and I somehow contaminated the batch when I cleaned the rods?

If I started getting gunk on the rod after about 10 minutes is that normal? And could I just stop there with maybe 5 ppm CS? I see where people are going for hours and hours.

Thanks again!
 

 
Printer-friendly version of this page Email this message to a friend
Alert Moderators
Report Spam or bad message  Alert Moderators on This GOOD Message

This Forum message belongs to a larger discussion thread. See the complete thread below. You can reply to this message!


 

Donate to CureZone


CureZone Newsletter is distributed in partnership with https://www.netatlantic.com


Contact Us - Advertise - Stats

Copyright 1999 - 2021  www.curezone.com

1.922 sec, (1)